| Heavy Duty Field Replaceable F-connectors that you can swap out with one 7/16" wrench |
| Durable Rubber Shock-Absorbing case with carabiner clip - longer lasting than neoprene cases |
| Weather-resistant tough aluminum extrusion enclosure with rubber gaskets vs. cheap plastic enclosure of competition |
| High Current Limit Level of 600mA that allows it to work with the Dish Pro Plus and Dish 1000.2 |
| Loud audible tone |
| Internal Rechargeable 12 cell NiMH 300 mAh Battery |
| Ability to see battery level remaining |
| Bright LED display, easily viewable in direct sunlight |
| Dual satellite signal strength measurements - can view and align two satellites at one time |
| NEW! Improved Heavy-Duty Field Replaceable F-Connectors (easy change with one 7/16" wrench) |
| 22 KHz tone mode to control multiswitches and multi-LNB dishes |
| Bright LED display, easy to read even in direct sunlight |
| Strong audible tone |
| Internal rechargeable NiMH battery |
| Able to power LNB from internal battery or IRD |
| Rugged, compact, weather resistant design |
| Includes DC Cigaretter Lighter Charger, AC Wall Charger |
| Short circuit protection |
| Switches 22KHz On/Off |
| High Current Limit Level of 600mA that allows it to work with the Dish Pro Plus and Dish 1000.2 |
| 950-2150 input frequency |
| Tests Coax Cable Runs |
| Selectable Audio On/Off |
| Able to check IRD Set Top Box Receiver Voltage, LNB current amps |
| Works with all LNBs |
| Able to align antenna quickly and reliably without the receiver |
| Frequency range |
950 to 2150 MHz |
| Impedance |
75 Ω |
| Measurable input level |
-48 to -8 dBm total power |
| | -60 to -20 dBm per transponder |
| Insertion loss |
6 dB (950 to 1450 MHz) |
| | 11 dB (1450 to 2150 MHz) |
| Size (H x W x D) |
6.5" x 2.7" x 1.1", 1.0 lbs |
| |
(16.5cm) x (6.9cm) x (2.8cm), 700g |
| Temperature range |
0°F to 125°F |
| |
(-17°C to +50°C) |
| Connectors |
Type F female (field replaceable) |
| |
| Power |
Uses IRD power when connected, otherwise uses internal battery. IRD voltage loss through the SAT Buddy is 1.3 V. Current consumed by the SAT Buddy is 90 mA. |
| LNB Power |
Current limited at 600 mA |
| Internal Battery Pack |
Rechargeable 12 cell NiMH 300 mAh, 12-16 V nominal, automatic shutoff, 1.8 hours typical use per charge. |
| Battery Charge Time |
±10 hours from wall charger |
| Wall Charger Output |
12 VDC, 200 mA, center pin positive, 2.1mm I.D |
| |
|
| Signal Measure Mode |
| |
Bargraph LEDs left row x 10, right row x 1 |
| |
Dual beep rate with solid tone at peak |
| |
|
| Current/Voltage Mode |
| |
0 to 500 mA (each LED segment is 50 A) |
| |
10 to 20 volts (each LED segment is 1V, above 9V) |